Replace the converter if it is swollen or leaking. Torque converter's balloon from too much pressure resulting in a whining sound heard at the front of the transmission. Check the studs and threaded mounts for stripping and wear and check the seams for leakage. Replace the torque converter if it has a bad one-way stator clutch. A good stator clutch locks in one direction and spins freely in the other. Insert a few fingers into the stator spines and turn.
If the hub has deep scratches or a significant groove, usually where the transmission pump seal was riding, it may leak transmission fluid into the bellhousing. Most of these are easily removed by polishing the hub with a piece of crocus cloth. Install the proper stator shaft into the proper pump coverThe dif. Check the drive hub for burrs and scratches.
Perform a complete inspection of the torque converter after removal. Without a sufficient amount of transmission fluid, the. this pump comes complete with all the guts inside, and has a 300mm stator. Improperly installing the torque converter's hub into the front of the transmission will damage the oil pump. Low fluid is one of the most common causes of problems for transmission oil pumps. this is a complete front pump for the 4l65e.Use a straight edge and a tape measure or a ruler. Use this measurement to ensure that the torque converter is correctly aligned with the transmission oil pump when reinstalling.POWERGLIDE - SUPER PUMP - RINGS INSTALLED FOR 207148 & 207159AV SUPER SHAFTS ONLY. Measure the torque converter's depth into the transmission's bell housing. ATI Transmission Front Pumps and Super Pumps for racing and high.After separating the engine from the transmission:
0 kommentar(er)
